|
|
Solder Mask Dispensing In-line
solder mask dispensing is generally used where screening the mask is impractical
because the board has been already been partially populated with components. In
addition, solder mask dispensing provides a cost-effective alternative in high-mix,
lower-volume environments, where the cost of developing screen fixtures for every
assembly may be prohibitive.
Asymtek systems can flexibly adapt to specific
requirements, such as masking a series of leads in a single dispense pass and/or
masking multiple boards at the same time with dual or triple headed configurations.
In addition, Asymtek's programmable systems allow the manufacturer to easily optimize
throughput, such as balancing the frequency of height sensing steps against the
predicted amount of board warp and the overall specifications for mask precision.
Videos
Dispensing Systems
- X-1010 Axiom™ SMT Dispenser
- X-1020 Axiom™ Semiconductor Dispenser
- S-820 Spectrum™ Precision Batch Semiconductor Dispenser
Pumps
& Valves
back to top
|
|
|
