| |
|
Some of the documents on this page are
in Adobe Acrobat PDF format for high quality print characteristics.
If you do not have the free Acrobat Reader plugin, you may download
it here.
|
|
|
|
|
|
SC-300 Swirl Coat™ Applicator
Versatile Coating In Three Modes
 The
SC-300 Swirl Coat applicator offers three modes of operation - bead,
monofilament and swirl. Ideal for conformal coating applications,
the SC-300 handles a wide range of materials, varying in viscosity
from 30 to 3500 mPa-sec (30 to 3500 centipoise). The SC-300 is designed
for use with solvent-less coatings, supporting environmentally responsible
practices.
The SC-300 applicator is easy to maintain and offers several key
features to make ownership simple. The zero-cavity nozzle tip prevents
material build-up during operation; it also allows for cleaning
without disassembly. There are minimum wetted parts to replace or
clean. The use of advanced materials, smooth internal surfaces and
exposed splines makes them easier to clean. In addition, the SC-300
requires no special adjustment during re-assembly -- coating performance
and fluid sealing are not adjustment dependent. Short pot-life materials
are easier to handle with this applicator.
For a broader selection of spray patterns, one of three airflow
extensions can be fitted onto the main assembly. The airflow extensions
along with the three spray modes provide coating patterns to fit
your application.
The high flow rate produces film builds quickly, while allowing
for fine control. The fluid passage provides uniform fluid flow
distribution. The air and fluid chamber are co-located so that there
is rapid response to changes in operation - there are no long air-lines
to delay response or to fail.
An optional four-position Tilt Accessory is available to allow
coating access to vertical sides of components.
Features
- Three modes of operation - bead, monofilament, and swirl -
for flexibility and control
- High flow rate -- fast, and fine control of film thickness
- Easy access design tip for cleaning; no disassembly required
- Simple maintenance; minimum wetted parts are easy to disassemble
and remove
- Easier handling of short pot-life materials; true zero-cavity
design holds no fluid at the tip after coating
- Four-position Tilt Accessory available as an option
- Ideal for solvent-less coatings
Dispensing Systems
Brochure
If you're planning to install an Asymtek piece
of equipment, please check with your
Asymtek representative for the exact dimensions. The dimensions
shown in the following
brochures are subject to change between publication dates.
back to top
|
|
|
